CrimeStopper FS-99 Instalační příručka stáhnout pdf (Strana 23)

PROGRAMMABLE OPTIONS

You can program multiple options in one session if you start with the lowest option and continue on to higher options

without repeating steps #1-3 below. For example, you can follow the programming steps to change an Option by

pressing button 1 to 4 on the remote, then you can continue pressing the program button additional times to get to a

high number option and change the setting without having to repeat Steps 1-5. You can only go from low to higher

option numbers in one session.

To Engage Option Programming:

1. Turn Ignition Key to the ON position

2. Press Program / Valet button 5 times, after a few seconds the unit will flash the lights and Siren Chirps 5 times.

3. Push the valet/program button [again] the number of times that corresponds to the option number desired (1 thru

30). You must get a light flash and chirp after each button press.

4. When you reach the desired programming level, Press button #1, #2 #3 or #4 to change the option level. The

siren and horn will confirm with 1-4 chirps. The remote control will confirm program option selection on top

right corner of display. Example option #6 button 4 shows *06--4

5. Turn Ignition OFF and check for changed features.

Note: The Program Mode Exits automatically after 20 seconds (lights flash 4 times on exit).

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 39 40

Žádné komentáře

CrimeStopper FS-99 Instalační příručka Strana 23